Page 1 of 1
Exup servo.
Posted: Sat Feb 14, 2015 10:48 pm
by coops
At what rpm should the servo start to move?
Re: Exup servo.
Posted: Sun Feb 15, 2015 1:29 pm
by Stig
cant start mine yet to confirm as the headers are on the bench but from memory its around 3000 (ish)
Re: Exup servo.
Posted: Tue Feb 17, 2015 2:30 am
by coops
Mine starts to move at 1500rpm and that's bang on cos its a digital rpm gauge. Suppose theres not much I can do about this?
Wonder why.
Re: Exup servo.
Posted: Wed Feb 25, 2015 3:44 am
by Kevadlilleke
According to the repair manual troubleshooting section, at 2000 rpm the EXUP should have started moving and if I recall correctly, at little under 6000 rpm it should be wide open already.