Page 1 of 1
Rear shock and swingarm bearings?
Posted: Fri Jun 07, 2013 8:32 am
by Kevadlilleke
1) Where would I get replacement bearings from?
2) Are there some reasonable product codes/measurements if I wanted to buy from a generic bearing manufacturer?
From the parts catalogue:
Code: Select all
BEARING, CYLINDRICAL 93317-52865-00 2pc
BEARING 93317-41761-00 4pc
BEARING 93317-42060-00 1pc
BEARING 93399-99919-00 1pc
Re: Rear shock and swingarm bearings?
Posted: Sat Jun 08, 2013 8:34 am
by Clanky
The Yamaha 'special bearing' used on a lot of bikes (93399-99919-00) can be very expensive:
The cheapest source I found for an original part is here:
http://www.boats.net/parts/detail/yamah ... 19-00.html
Another source for a non original part is here:
http://www.splatshop.co.uk/shock-bearin ... e12pw.html
Here's a link to another forum for FZR1000 owners that may help:
http://www.exup1000.co.uk/phpBB2/index. ... 54f1e1a046
Can't help you with the other bearing sizes because I don't have a 1000 myself.
Re: Rear shock and swingarm bearings?
Posted: Tue Oct 15, 2013 7:59 am
by Sparky 61
What bearings are you looking for? just swingarm bearings or the suspension linkage bearings? I found that just surfing the net and mailing bearing manufacturers with the internal/external bearing sizes and the bearing make up did the trick. I found a really good one here in the UK.
Re: Rear shock and swingarm bearings?
Posted: Tue Oct 15, 2013 5:01 pm
by Stig
Banner over at my place has just done 90% of the rear suspension bearings with aftermarket items and saved a packet
http://www.exup1000.co.uk/phpBB2/viewto ... &start=180
Re: Rear shock and swingarm bearings?
Posted: Wed Oct 16, 2013 3:28 am
by Sparky 61
I know, if you look at the close ups of the swingarm I have installed grease nipples to this as well.