Confused as usual!!!
Moderators: Site Director, FZR Forum Moderators
Confused as usual!!!
Perhaps this site has been redone, I don't know. I thought for sure I had some posts on here. At any rate, I have been on my computer all day looking for a 93 - 95 servo motor and cables for my 93 FZR 1000. If someone could tell me where I might go to look for this item either here or somewhere else, I sure would appreciate it. This bike is starting to stress me out. Thanks much for any replies.
Re: Confused as usual!!!
last time i was on ebay looking i found a few servo motors, but that was in the uk. I have been searching for the exup valve and cables since i bought the bike with no luck.
http://www.ebay.co.uk/itm/YAMAHA-FZR100 ... 35bb885a5d
Iv now got a small list of parts i need to find: rear shock, exup cables, exup valve, renthal bars,and twin spot headlights the last two are not really needed but i want them.
http://www.ebay.co.uk/itm/YAMAHA-FZR100 ... 35bb885a5d
Iv now got a small list of parts i need to find: rear shock, exup cables, exup valve, renthal bars,and twin spot headlights the last two are not really needed but i want them.
Re: Confused as usual!!!
I'm not sure about the servo itself but I do know that 98-01 R1 exup cables are the same. I run them on my 94 1000. Could be very well the same servo with a different part number. 96-96 YZF1000r (ThunderAce) servos should be the same or similar as well. Might want to spend some time looking at the parts fishes to make sure.
Duane...
Bike:
1994 Yamaha FZR 1000 EXUP
Factory Pro Stage 1 Jetting | K&N Filter | Corbin Seat | ProTek Keyless Gas Cap | GSXR Mirrors
My Thread
Cage:
2005 Saab 9-7x 5.3i Arc AWD
THE WIKI IS YOUR FRIEND
THE SEARCH IS YOUR SIGNIFICANT OTHER
USE THEM!!
Bike:
1994 Yamaha FZR 1000 EXUP
Factory Pro Stage 1 Jetting | K&N Filter | Corbin Seat | ProTek Keyless Gas Cap | GSXR Mirrors
My Thread
Cage:
2005 Saab 9-7x 5.3i Arc AWD
THE WIKI IS YOUR FRIEND
THE SEARCH IS YOUR SIGNIFICANT OTHER
USE THEM!!
Re: Confused as usual!!!
Thank you all for the info. I found a 97 fzr 600 servo that has the same connector and looks the same. Hopefully it will allow my bike to rev past 4k now. Now, I need to find the cables and I will be set. I don't understand why everyone is eliminating these valves because I've heard no positive results from doing so, only complaints. 
Re: Confused as usual!!!
I removed mine just this year. After 7 years of listening to the valve rattle and people asking me, "Whats that rattling sound?", It had to go. I'm not missing it!!
"In like Flynn"
Re: Confused as usual!!!
maybe it needed now end bushes or the valve adjustin so it didnt rest against its stop...shame to lose the low down gruntofloinn3 wrote:I removed mine just this year. After 7 years of listening to the valve rattle and people asking me, "Whats that rattling sound?", It had to go. I'm not missing it!!
