Shorten Dogbones

[basstracker]

Has anybody shortened there dogbones? Good or bad

[cowboi]

you might want to talk to nate memberlist.php?mode=viewprofile&u=141 (thatkid) he does things like that.

[lamer]

err.. wait up Shorten the dogbones. Please tell me your NOT going to cut them down then weld them?

Shorter dogbones raise the rear ride hight, read this if you haven't already? http://fzronline.com/wiki/doku.php?id=dog_bones

Adjustable dogbones professionally welded are available from reelrazor read this thread http://www.fzronline.com/forum/viewtopi ... =18&t=3873

[Stig]

Has anybody shortened there dogbones? Good or bad

If you know what size you want and wish to stick with it, then I do stainless items. I can do any size you choose from high lift 155's to intermediate 158's or even standard height
Not too sure where you are but theres a saving for forum members over the ebay price that i do when posted to the UK, and i'll post overseas at cost if required

If I dont stock the size I can get them done at a weeks turnaround assumng theres no problems at the cutters

http://www.ebay.co.uk/itm/150711425222

regards
Paul

[basstracker]

Yeah I ended up making them out of t6 aircraft aaluminum at .26mm or 1/4 inch thick width the length 155cm or 1550 mm from center to center of mounting holes raising my tail aprox 2"! Super cheap build and made a great difference falling into corners! Dont waist your money ordering them!

[lamer]

Yeah I ended up making them out of t6 aircraft aaluminum at .26mm or 1/4 inch thick width the length 155cm or 1550 mm from center to center of mounting holes raising my tail aprox 2"! Super cheap build and made a great difference falling into corners! Dont waist your money ordering them!

Ah... you've figured it all out by yourself.

Glad to have helped

[basstracker]

Haha lamer if u could only ride as good as u spell!

[Stig]

Yeah I ended up making them - length 155cm or 1550 mm from center to center of mounting holes

[dan83590]

Yeah I ended up making them out of t6 aircraft aaluminum at .26mm or 1/4 inch thick width the length 155cm or 1550 mm from center to center of mounting holes raising my tail aprox 2"! Super cheap build and made a great difference falling into corners! Dont waist your money ordering them!

Stigs dogbones are as good as you will get anywhere and they are less than £14.00 for a pair. Why bother purchasing the materials and machining them yourself.

[basstracker]

Im just talkin trash, props to anybody with an FZR!

[crowe]

Old topic i know but i've got 155mm dog bones on my 1000ru, the back end is about 40mm higher than standard and has sped up tip in and direction change no end!!

Best £13 i spent!!

P**s easy to fit and makes an instant change!

Only thing is the bike leans further on the side stand and if your legs are short it could be awkward but well worth it!!