FZRSupport: the FZROnline Archive

thank you soooo much. i got it hooked up right and fired it up today. runs like a champ!!!!! thank you thank you

i just uploaded 3 pics in my gallery of the VR and the wires. there are 5 prongs on the VR and 4 wires coming from the harness. how do they hook up?

thanks. i will do both of these things tomorrow. and let you know. im pretty sure the VR is a newer one.

i got my bikes electrical put back together to see if i could start it today (its in the middle of a re-/street fighter build). i started the bike up and it ran for about thirty seconds, then it died. i couldnt start it back up so i started looking at things and found that the 30 amp fuse that goes ...

where do you get the lube and how do you apply it?

thanks for putting them up for me. why cant i do that?
i guess there will be more pics to come when i get going on my new back end

there is a picture up of it now in my gallery. you can see new new bars too.

im going street fighter with my bike and decided that a single seat would be best for the shortened tail. when i told my wife about my idea she got upset cause she thinks she wants to be a passenger sometimes when i go riding. but i still wanted a one peice seat, so i got out the hack saw and went t...

i adjusted a few things and now the throttle cable is barely long enough and the brake line is like 3 inches too short. i know of a couple shops i can go to. hopefuly it will not be too big of a hassle. in other news, i finished my custom one piece seat yesterday. ill do a post for it later.

like, one and a half inch risers w dirt bike bars. should i take it to a bike shop?

i have a 93 fzr 600 and im going street fighter. i bought a set of risers and handlebars, got em installed and put the controls on. the new bars are taller than before and now by brake line befre it y's to the front brakes is too short by 2 inches and my throttle cables (there are two of them!?!) ar...

i will be doing a custom seat job very soon. ill make a new thread when i start. i will be combining the rider and passenger seats into one seat to look like the new triumph speed triple... http://www.flickr.com/photos/24904297@N04/2465840278/

thank you so much for the help. i got the tree off a few hours ago. and now i know how to properly put it all back together. i am one more step away from being a newby.

the bike is up on stands now and forks are already off. i was trying to slide new forks in but it wasnt lining up right so i think the lower part of the tree is bent. thanks for the help!

how do you take off the tripple tree upper and lower? i got the top nut off by the ignition but what is next? do i need a special tool? thanks far any help?