FZRSupport: the FZROnline Archive

St.Louis Missouri 1994 Yamaha FZR600 42,621 $1000 OBO Reason: Got a newer bike and I don't ride it anymore https://dl.dropbox.com/u/26801217/fzrphotos/2011-09-08%2014.34.50.jpg https://dl.dropbox.com/u/26801217/fzrphotos/2011-09-08%2014.35.02.jpg https://dl.dropbox.com/u/26801217/fzrphotos/2011-09-0...

So i got the bike out and it started right up, I was cleaning out the garage while letting it idle. then all of the sudden, the bike shut off. Tried to restart the bike but it won't crank. I checked all of the fuses and the ignition one was blown, so i replaced it. Then i tried to restart the bike a...

does anyone know if the YZF had 32mm carbs at one point and later in production they changed over to 36mm? if they did, do you know when they made the change?

crishard which site for yzf's are you a member of? I've got some 4TV parts to get rid of.

anyone know how to mount the bearing and collar on the output shaft of the transmission. it's an interference fit and i lack i hydraulics press to put it on, any ideas?

is there any interchangeability between an FZR oil pump and the YZF oil pump?

with the 660 conversion i will be able to keep all the stock FZR wiring and controls right?

also any tips for getting a clutch basket off when it is spinning like a top when I try to use a wrench?

does anyone know where i can get that 3mm spacer?

Thanks Again David M.

Hello, I got a YZF engine a while ago and I've had an FZR engine laying around for years. Up until I took apart the YZF engine I didn't know it was one, I though it was an FZR engine. I wanna do a rebuild on the FZR engine and need a few parts out of the YZF, please let me know if the parts are inte...

Hi, I've got a spare FZR engine I'm gonna rebuild, the gasket kit i have in mind is this one: http://www.denniskirk.com/jsp/product_catalog/Product.jsp?skuId=&store=Main&catId=&productId=p261297&leafCatId=&mmyId=666 has anyone used this kit and liked/disliked it. If you used a different kit can you ...

what gasket kit did you use to rebuild the engine? by chance was it this one: http://www.denniskirk.com/jsp/product_catalog/Product.jsp?skuId=&store=Main&catId=&productId=p261297&leafCatId=&mmyId=666 it's the vesrah full gasket kit. if you didn't use this one could you link which one you got and whe...

The wiki on for everything about carbs is missing the syncing section. that isn't a problem i found a tool i think will work. I also understand the principal behind how the tool works. my question is: does someone have a picture of where the tubes need to connect into each of the carb sub-sections? ...

but i tested the pickup coil and it tested at ~100 Ohms.

ok so i just went out. the was voltage coming out of the digital ignitor. but when i tried to start if the STARTER SWITCH ASY http://www.cyclepartswarehouse.com/fiche_section_detail.asp?section=23274&category=Motorcycles&make=YAMAHA&year=1994&fveh=590 #9. it was vibrating and making a funny noise. i...

there was last time i checked, middle of last week. the batt is dead right now so I'm charging it was will check again tomorrow.

OK, so i tested my ingitor on another fzr in stl. the ignitor thing is fine, His bike fired right up. so not really sure what to do next.