FZRSupport: the FZROnline Archive

I got all the carbs cleaned out reset the fuel/Air screw 2.5 turns out and new fuel again and she is running good it takes a little bit longer to start than she used to but when you rev it I can get 13,000 rpm no problem but as soon as I try to pull away it dies any way I got sick of not riding it s...

OK will give that another go and post results fingers crossed

Fuel hight on carb 1 (all about the same )[attachment=0]IMAG0767_1_1.jpg[/attachment Bike still won't start unless choke on even when hot runs at about 3,500-4,000 rpm with choke on then when choke turned off it either dies straight away or runs for 10-15 seconds then dies when it does run for 10-15...

Cheers for the help lads willandrip have you done these carb setups before ?

Hi this was the kit I used I was looking for the fzr600 kits but was told this is the kit I needed for the fzr600r and it seemed to fit OK

Hi it was running a bit rough / lumpy then I left it for about 3month in the garage and when I came back I empty'd all old fuel drained carbs then added fresh fuel then tried to start and it wouldn't start at all and fuel started to drip from over flow pipes on carbs I was advised to clean carbs and...

FB_IMG_1434358195097.jpg h Hi all I needed to take my carbs off to clean them FB_IMG_1462645304906.jpg -took float bowl off -took float and float Needle off -took brass fitting/gauze out (where float Needle sits) -took main jet out (middle hole) I think -took idle jet out (left hole) I think -took ...

baggers wrote:THe rev counter is going haywire too, could this be a problem with the CDI unit?? It goes up to about 8k RPM, then back to zero in a kind of random pattern..

I found this out to be the connection under the tank clean terminals and make sure the plug goes back together fully