FZRSupport: the FZROnline Archive

Evilchicken0 wrote:Why don't you just fit a 1wg / 3he reg rec and have done with it ?

I was under the impression that they had a high failure rate. Both the Wiki's at FZRarchives and here indicate to upgrade to a YZF/R6/R1 VRR at all cost. So I was following what I thought was good advice.

Thanks for the insight. I've found the page you were referencing in the wiki here.

I'm looking at replacing the original voltage regulator on my 1988 3BF, but I'm confused. I've checked out the CPR for the VZR topic in the old archives, but all the years referenced are newer than my bike. There seems to be a ton of voltage regulators available. Is the RM30X01 from RMStator a viabl...

Took a couple of times, but I've got them all back. Thanks for the assist guys.

Will do. Thanks guys.

Thanks for the additional information. The more I have before I start, hopefully the less likelihood that I'll screw something up... well, more than I already have. ^_^

Thanks. Sounds like I have quite a bit of trial and error ahead of me.

I tore down my engine and installed new piston rings. 3 were seized on two different pistons. Anyway, I didn't realize there were pads inside the lifters until I opened up the container I had put them in during the reassembly process. The pads have different numbers which I'm presuming means they ar...

I ordered the head gasket and cylinder gasket separately because I read they were different than the originals. The ones that came in this kit looked identical in material and shape to the OEM gaskets I purchased. Just in case anybody was wondering.

I ordered one of these kits. Here's a picture of all the gaskets included.

Thanks for the additional information. We'll be putting the engine back together in a couple of weeks and will be purchasing new ones. I don't want to pull the carbs back off after installing them.

Thanks. I've also seen where people have been boiling theirs in antifreeze in an attempt to rejuvenate them. I plan on replacing mine, but was curios.

I know they are still available, but that really wasn't the point of the question. I was just curios and wanted to know the results if somebody had.

Thanks for the additional information.

Has anybody tried to make a carb joint, part number 1WG-13597-00-00, out of radiator hose before? It's the rubber that goes between the carb and intake of the engine.