FZRSupport: the FZROnline Archive

just as i figured but il still ride the season out without it and fix it in winter. Throttle sticks kill switch still works

What is the purpose of the second throttle cable the one on the bottom or if you open the throttle the one that wraps almost all the way around the throttle handle? Reason I ask is i seen mine was a bit rusty on the inside and squirted some pb down it and pulled it a bit, and out it came. I put the ...

Nice he did the same thing i did just a hair different. And his is a bit smaller i wasnt sure if i should go smaller but looking at his i may just do that. I dont like where his turn and plate is located its to far under which you can see in one pic it is pretty dirty. Just like he said its a hella ...

As soon as i get home while the bright sun is out il take the bike outside and get a good pic but here it is pretty much done

Exactly, figured for the mean time il just hack up what I have and if it looks horrible the wife will allow me to order some new stuff . But so far it isnt looking that bad for costing me nothing more than a sheet of metal.

A tail that works was sitting in my garage the whole time. Just needed a saw and welder :) . I took the fender cut it more areo dynamic and I took the under out and going to put a new one in with sheet metal. I cut my light bracket and rewelded it higher then cut out the rear peice of plastic so it ...

the stuff i seen at maier website was just stock i dont want stock rear they are ugly.

i thought i read that the air tech stuff was thin fiberglass? iv looked at them and would consider as long as they are not junk cause they are pretty much direct bolt on.

Of course the popular is the r6 but after looking at all the parts needed it adds up fast. Now i seen someone had a cbr tail and used fzr seats so only cost was tail and light. Any others work where all you need is the tail and light? Bending, shaping, welding, and drilling does not scare me.

well i found something on the net that basicly said you have to do it like a car pump, hold, open, close, release. Done this a couple times and it improved.

Well i got my master the other day and i bought a brake pump kit from auto store. Well i hooked it up and flushed all the fluied till it was coming through clear and no air i think. Checked the brakes and it stopped in the garage by me pushing it. Well took it out today and it is no where near the s...

ya im worried about the kickstand cause it leans alot and im affraid if i park somewhere and it is sloped im gonna fiddle trying to set my bike right. But ya im liking it more i decided to ride around my area a bit and if feels nice. I tried pulling into my drive at my normal speed and well it wasnt...

I dont have a front brake so i only took it around the block, when i get my master cyclinder next week il ride it more.

I picked up some 3/16 x 1 1/4 steel and made the dog bones. I just did what the wiki said and made the holes 5" apart. At first i had the shock at 7 and i couldnt flat foot the bike perfect so i reset the shock to 1 and now i can flat foot it just fine. Il play with the setting over time to find the...

i buy steel all the time just to have on hand for when i weld something or rig something together. I know it comes in all kinds of thickness and width is usally inch up to like 2 inches wide. Im just wondering if its strong enough cause the stock bones are pretty thin but must be storng metal.