FZRSupport: the FZROnline Archive

If you can't find someone to buy used, you can buy it new from these guys. Wow, that's perfect. Thanks much! was looking online and none of the plugs I looked at seemed quite right (though a lot were close) which is why I went looking for a junk unit to scavenge. This is probably better than what I...

Exactly as he title says, I am looking for the plug and a few inches of wire from a stator for the FZR600. Mine appears to have had some arcing from a bad connection and is a little melted. Though it was charging decently, I'd rather fix it right than get stranded somewhere. Let me know if anyone ha...

So I stripped the hole where the bolt goes that holds the shifter pivot boss to the shaft that goes inside the transmission. I tried a new bolt as the threads on the end were a little jacked up but a new one won't tighten very well either. Is this as simple as getting a replacement shifter (or maybe...

That doesn't really sound like it bled all the way, you should get resistance when the hole is covered with your thumb. I've seen instructions like "pull the lever half way, plug the outlet hole, release the lever to draw in fluid, repeat until you get good resistance on the lever." I did mine still...

I would check out that stator, the entire electrical system on these bikes is picky but pretty simple and it just might run better with the right voltage. I had a broken connector on my stator where it plugs into the rest of the harness that I had to replace because I could see my lights randomly di...

Hey, another WI rider! If you're on the lakeshore let me know. Does your bike behave any better with the airbox on? I know that without jetting these bikes tend to run a little funny without the box. If it still won't behave then a carb cleaning might be in order. I'm no carb expert, but these didn'...