FZRSupport: the FZROnline Archive

Has there been any dyno discussions on a fzr600 with efi and/or alcohol injection. Is there competition for a modern r6 that's 3 to 4 years old?

That's a good point. I've been flowcharting the the biz model and realistically looking at the revenues, and have'nt reached a definitive conclusion yet. Do you still powder coat?

Thanks for the input. I generally feel the same with regard to people looking for a "cheap" bike, but I wonder how it would do to transistion into a high-performance race engine (either in alcohol or efi trim)? I want to avoid the idea of a "bone-yard" full of old fzr's. It's in the planning stage r...

Don, I thought I would ask the general question that I've been kicking around for the past few months. First, excuse me if this isn't the place for this post, but I felt that you (from our previous conversations) had the present knowledge with regards to this topic. I've been playing around with som...

I just wanted to say that this is one of my favorite posts for aspiring bike builders, and it deserved to be mentioned for people that haven't had the thrill of reading through it. It is a good study in design, fabrication, and innovation. It gets an A in my book! P.S. - For those that keep up with ...

There are no side fairings. Front fairing is in poor to ok condition. It is solid but needs a repair to the right turn signal hole as there is a chunk missing. Also a few stress cracks but nothing beyond repair. The rear side fairings were smashed and I've repaired them with sheet metal and fibergla...

Parting a 91 FZR (single headlamp) that has been thoroughly inspected. Contact me regarding availability. Purchased bike for the stator and a few other bits, but stator was not good. If there anyone that is willing to trade part for good stator i am open to offers. Thanks.

Looking to buy a 5-pin Flasher relay (Denso 79011). thanks.

Do you still have the Digital Ignitor (TCI)? Headlamp?

Im looking for a Ignitor Unit for a 92 FZR 600. Thanks.

Looking for front fork inner tubes, if available?

I am looking for some straight front fork inner tubes. Please post with any reasonable offers. Thanks.

Bought a 6-ton Hydraulic Press yesterday, but didn't use a fixture to straighten the tube...I am looking for some straight inner tubes.

Is there any improvement to this press? I'm not having much luck with the straightening. I've already had one explosion from the first design and upgraded to a heavier scissor jack. Do you think it would alter the integrity of the inner tube if i heated it a bit? My only option would be to pound it ...

Can't you heat or use penetrating oil on rubber?