FZRSupport: the FZROnline Archive

Thanks everyone for the input, The problem has now been solved, The issue was with Glazed steel plates i took some fine wet and dry to them then cleaned them up with brake cleaner to make sure i got rid of any fine metal particals,

and now it works as it should.
cheers

Thanks for the replys, I have checked the push rods and they appear fine and in good condition,

Does anyone know what the clutch stack height should be? I measured mine to be 42mm

Cheers for the imput, I have checked and checked springs are correct, everthing actuates as it should, the only thing i have not replaced is the steel plates but i have checked thickness and warping and they fine, the only thing it could be i assume is the oil it put in, if it is I am a little annoy...

I have just checked the pressure plate and it is in the correct position had the plates out just to check i have not made a obvious error and all appears as it should as per the manual I have, it engagers gear with a bit of a clunk but nothing major neutral is easy to locate so i assume there is no ...

Thanks for the reply guys,

the oil level is fine its only just had a oil/filter change about 200 miles back, basket looks good as new, I did check for warping they looked good,will check as for the pressure plate hopefully this will be my undoing

I soaked them in brand new 10 40 oil for 3 hours as recommended in the brief instructions on the EBC box.

Hi People I have a small issue with the clutch slipping on my Fzr 600 3he 1990, I have changed the friction plates and springs EBC items, I adjusted the cable up on the sprocket side (lock nut loosened turn the screw until you can feel slight resistance then 1/4 back tighten lock nut back up) but it...

I would just like to post a thankyou, to all on this site and the of course ownerof this site for you all being a great source of info, my FZR 600 has just completed its first stage of completion, I have spent much time trawling through posts looking for answers. I am waiting until i have further fu...

I have been out and I think the steering head bearings are the culprits when turning lock to lock there seems to be a "notch" so have ordered some bearings

thanks for the replys

Hello People i am looking for any suggestions of where to start looking with a little problem i have, I have just finished refreshing my Fzr 600 1990, I have done the following New tyres front and back new wheels bearings all round droped the shock and swingarm regreased all needle bearings shock is...

Cheers for the imput people, much appreciate they are all back together now just have to wait until i get the wheels back from painting to see if i was succesful

Hello, I am just changing my fork seals in my 3He, great write up just on question regarding which way to install the springs, in the picture you show the smaller pitch being at the top of the fork, but in the online yamaha manual i found it stats the larger pitch to be at the top which is the oposi...