FZRSupport: the FZROnline Archive

thanks reel razor.. i have been offered an fzr shock, but hes not sure what it came off... looks the same as mine.. no external gas cylinder... he says its got 2GH 00 written on it?? there is also a 2006 fzr1000 shock that looks similar.. will the 1000 shock fit?? i am looking for a cheap replacemen...

Hello all, Took the bike out yesterday and after an hour I was gritting my teeth with the pain in my lower back. Even the slightest edge on the road surface was being translated straight up my spine. i noticed as i was going over bigger bumps that there was a ungainly noise as the rear end came off ...

The bike flys now, starts on the button, brand new rear tire, 18000 miles needs and MOT and Tax.. No reason it will fail, bearings, brakes, lights, all good. there is a slight stumble in the first 16th of the throttle although my mate who tested it with me said he couldn't notice it, but i could..) ...

:tks: :tks: :tks: :tks: :tks: :tks: :tks: :tks: Just to let you know, put the carbs back on after all the adjustments and the bike flys.. goto be 30% better everywhere.. Me being a perfectionist, there is a slight stumble at the first 16th of the throttle.. which I am not sure what to do about?? My ...

Hi there , I was kindly given this clear explanation of how to bench sync my carbs on my fzr600 by DonTZ125.. Bench-synching the carbs - you want to use the smallest possible drill bit; 1/2" shanks won't work! Some guys use piano wire or safety wire. I believe the #2 carb is the 'master' - slip the ...

Alright chaps, whats happening.. just going over my current bike adjusted the clutch and cleaned the plugs, reset the ht lead caps, wanted to take the petrol tank off and noticed there was a build up of some sort in this rogue rubber pipe... was reading through the yammy manual and it is the crank c...

Thanks for the reply DonTZ125.. Point taken on the frustrated racer rant.. Bear in mind that I am talking about slow moving manoeuvring 5-20mph.. typically second gear corners around town.. there is a higher friction type of sound from the engine and this seems to catch and then release repeatedly (...

Just got a new 90 plate fzr600... :thumbsup: Amongst the long list of things that the bloke who sold it didn't tell me about.... :tks: bonkonhead is that, at slow speeds when decelerating (say as you go into second gear for a slowish corner..) using the resistance of the engine to smoothly slow the ...

alright chaps, in the middle of checking and adjusting valves.. undone all the cam shaft caps.. (1 and 4 on the inlet were upside down and in the place... i.e. 1 was upside down where the 4 should be and vise versa?) some previous person in a hurry perhaps? Anyway, with the cam caps all off, the cam...

thanks for the info icequeen, i've been told that i need to get hold of an 90 R oil cooler and block off the hose that goes to the existing integrated oil cooler from my RU 93 radiator. Apparently the output pipe from the coolant pump on the 90 R has a different connection on the end than the input ...

just got delivery of my replacement engine and it has two filler caps for the oil... been outside to check mine and it has one.... the exup servo covers the other fill hole and i think it is permanently sealed.... this new engine appears to be an earlier exup (90??) and mine is a 93. :headscratch: :...

Just did a "plug drop test on my bike"... BY removing the cap from.. Plug 1 Engine cuts out from idle. (When i first got the bike on initial examination of this plugs it was very sooty/coked up.) plug 2 Engine cuts out from idle. (When i first got the bike on initial examination of this plugs it was...

nice one don, makes sense. I have sprayed tons of penetrating fluid and jumped up and down on it a bit.. gonna leave it and then use your jack info to disassemble, clean and grease it up tom... :tks: :tks: :tks: B y the way you cant help me with my running problem scenario can you?? its under anothe...

hello fzr people, I swapped this fzr 1000 exup 1993 for my motor from a Gypsy about four days ago... It has been hacked into some semblance of a street fighter... except it has no.. speedo, rev counter, temp gauge, working lights... When i rode it home the first ten minutes took my breath away... lo...

thanks dontz125, that sounds like it makes sense...i'll crack on..

i have a couple of jacks..wondering where would you place the jack head underneath... reckon the exhaust is strong enough..???

cheers mate..