FZRSupport: the FZROnline Archive

Thanks for all the possible reasons. The shock was from an 09. I did not do a static sag check before I replaced the shock. I did take before and after measurements unloaded [cant remember if i was loaded]. The fzr spring was definitely longer than the r6 spring. Kind of tuff to put on those spring ...

I swapped the stock shock for the r6 with the fzr spring. I used the adjustable dog bones set to 138mm center to center. My rear ride height increased by 40mm. It seems that the bike should have been about original height with r6 shock and 138mm bones. I measured the orig ride height from same point...

Sounds like the relay if your battery is up. You can take the big wire from the starter off the relay and firmly hold it to pos. side of battery starter should spin. If it does most likely its the relay not much else to the circuit. The starter button is working since it clicks the relay. The relays...

Never mind ordered a set. Just thought one of you guys would have known this off the top of your head. Id have to drive 200 miles to measure mine, stuck on the job. I guess I will modify if they dont fit.

I need to know center to center spacing on the front forks.
Also the swingarm width
Im out of town and want to order some universal stands. I know that one of you fzr maniacs knows it in their long term memory. Thanks

Hey Ive owned a lot of boats through the years that are kept in salt water which is the toughest environment for electrical. My conclusion is that crimp connectors are junk and can develop a lot of resistance over a short amount of time. I clean the copper on the wire with an eraser especially if it...

So for 30 more bucks and they throw in another part with the wheels and then you have both the front and back stand. Both for 80 plus shipping. Seems like a decent deal for some cheap stands. Thanks for the responses I think I'll get it with the additional part to make 2 stands.

I need to order a stand and discount ramps has one for 50. bucks that will convert to front or rear, spool or non spool . I believe its called the all in one. Any body have any knowledge of these? Also in the manual it looks like a bolt going up the fork tube on the left side of the fzr? Will this n...

Thank you all Its good to get feedback and save some precious time, and possible damage

Cool thanks, I didn't think about the use of jack stands under the frame sections that seems like it will help a lot.

Where is the best place to attach to the bike to hang the front end for suspension work?

Reel Razor, I pm you but I haven't received a response I read that some people are having problems with the pm so I thought I'd try here. Im just a nut and trying to get this buttoned down. In response I do go over 200 pounds so yeah I guess I will use my stock fzr spring. I guess then that I do nee...

Thanks again. Yea mon going with the 1.0 based on my reality weight and the weight of the bike based on the manual here on Wiki quite a lot heavier than the preset weight for the fzr on Race tech site calculator.

Thanks for the response the old scale further helped my decision I was quite a bit heavier than I thought. Im going to have to think about not eating from the taco truck. Probably the best performance mod and I will be saving money.

Ok Id like to order racetech fork springs along with abunch of other stuff from bike bandit. Problem they do not have the reccomended spring rate they have 1.o kg and .9o. Reccomended rate is .94 for the street .99 racing. I will be street only. Should I bite the bullet and pay the extra shipping, p...