FZRSupport: the FZROnline Archive

The bike has a full yoshi exhaust and not the stock header.

Hi,the bike has a not working exup.The yoshimura exhaust won't take the exup,cables where missing but the exup motor is still bolted to the motor and to the cdi but nothing else is attached.Does the cdi have a rev limiter or not?.Carbs where all cleaned.Thanks

Hi,I have a 1991 Fzr1000 to use as a track bike only.The bike has a jet kit and a yoshimura exhaust.The bike starts and idle great but when I slowly increase the rpm and reach 5k the motor start to missfire and few pops are heard from the exhaust and won't rev higher.It's like the motor hits the rev...

Got it.Thanks

Sorry but do you have the link for that site?.Thanks for helping me out.

Ok...one part of the float is smaller and higher then the other.I guess you measure the bigger float height...right?.Thanks BTW I have the Haynes service manual.I checked the carbs specs as you told me to do but there is no mention about the 14mm float level there.The manual mention only 10.6-11.6mm...

ok...and may I ask where you got that number?.thanks

"you are measuring not from the float arm to the top of the main jet, but from the top of the float to the gasket surface."
Ok....and what the mesurament in mm. should be?.Again...there is not mention about this on the manual.Thanks

Ok...I will take a look at my tz manual.Thanks
Btw:I make footpegs for the Tz 125-250 4DP with 6061 alluminum.For sale $35.00 plus $5.00 shipping.See pics on the Tz250racing.com.Footpegs topic

As a TZ racer, you should know how to do that - check your service manual, but instead of measuring up to the main jet tip, measure down to the carb body gasket surface. I guess you don't own a fzr1000 otherwise you should know that the service manual mention only how to measure the fuel level by u...

hi,the service manual does not mention how to adjust the float in mm. but only how to check the fuel level.

As yamaha_george said, there are pretty big chances to have the wrong float heights set. it happened to me when i tried to start a '92 1000. I set the floats to 14 mm (i hope i remember correctly) then it was running like a champ. How you do that?.Yamaha service manual does not say how to set the f...

Yes and there is no gas inside.

Hi,I just bought a track bike.The bike runs great but there is a gas leak on the carbs.I replaced the bowls gaskets,floats assembly small orings,pilots,mains.Fuel level is to oem specs.Carbs don't leak when the motor is not running.I start the bike and after less then 1 minute the gas starts to drip...

reserve switch, get low on gas or you notice sputtering hit the switch -get some gas What he said. It's basically sends a "cut off" signal to the coils (causing them to turn off and on-hence the sputtering) to let you know you're low on gas. That what I wanted to know.I won't need it on a racetrack...