FZRSupport: the FZROnline Archive

Hi all

does anyone know if a predetor end can Fzr600 3he 93 model would fit a Fzr600 3he 89/90 model is it a straight swap or is there any modification required

cheers al

I have a 3he genesis, i had it fully serviced for the summer tickover 11k the first issue is on start up i always let it warm up before riding it, when i select first it always stalls this happens 4-5 times before i can set off second after a ride out i called in at a mates for 1 hour , on setting b...

So if i stick with the 15t front 46t rear but go down the 520 route im good to go how many links though , I have seen these on ebay, is this the same for the 89-90 3he http://cgi.ebay.co.uk/YAMAHA-FZR600-92-93-DID-X-RING-CHAIN-AND-SPROCKETS-KIT-/280379158478?cmd=ViewItem&pt=UK_Motorcycle_Parts&hash=...

use the wifes nail varnish remover works for me

thanks for that sweekster,

just taken the sprocket cover off and wow what a mess so much gunge and dirt, but on a plus the clutch is smoother now after removing all the crap and re greasing the clutch realese mechanism ,


it has a 15t front and 46 rear am i ok on these

Cheers
Al

Hi Guys , been new to FZRs ,what should be the standard size sprockets front and rear be on my 89-90 3HE noticed that the rear is a 46 tooth and what do you suggest for a chain x ring o ring , did RK I have got a few tight spots on the chain and even if i slack off on the adjusters it still there, s...

check your pilot jets

finally finished the FZR for the MOT then its out on the road , its not mint as i did want to spend too much cash , but serviced and tidied up

Ok guys need some help , there is some play on the rear wheel of my fzr600 3he 89-90 model (twin round headlight) there is 3-4mm play in the rear wheel, is this acceptable or is it time for new bearings,or is it cush drive rubbers, I have tried to look in the manual for the sizes of the bearings but...

Hi Guys, one of my fork stanchions is pitted and is leaking badly , needs replacing for the MOT ,I was looking round on ebay for a replacement , but £100.00 for one stachion ?? I managed to locate a NOS full fork leg for £80.00 , which i thought would be a dam sight easier to fit than stripping the ...

Hi guys, it’s been a little while since I was last on, been busy with my bike club. I am getting some gear box noise. Symptoms are a bearing noise which is noticeable at idle in neutral and decreases with the clutch pull in. I have replaced the clutch basket needle roller bearing thinking that may ...

get your self some new plugs, if the plugs looked nasty , and although you have cleaned them up they still might be no good , it will be a case of elimination

have you tried putting the old fuel filter back , i presume it did run before the carb strip down, its sounds as if your nearly there and it probally some really simple you have not done,

you have hooked the starter lever arm onto each starter plunger

just got one of these for mine £39.99 plus delivery
http://cgi.ebay.co.uk/Avon-SuperVenom-M ... 2a04b9573a

Hi Guys , I have noticed that my fuel pump on my FZR600 genesis (89) is starting to whirr even longer than normal,before I packed her away for winter it whirred for a couple of seconds when switching the ignition on , but now its maybe 5-6 seconds ,this is my first fzr so what i really want to know ...