FZRSupport: the FZROnline Archive

hi just done this mod, you need everything clipons ,front wheel, speedo drive as axial is thicker, forks and yokes . your 4 pot calipers will fit so will discs plus the steering lock ignition , but please be aware that on full lock the clipon pinch bolt just touches the front of the dummy tank . it ...

hi all thanks for the interest but all SOLD !!!!!!! guy from stockport came and bought the wheel and shock. came via a work college so thanks for the interest cheers

please read original post cash on collection or sort out your own Currier
already been down this route with the hugger

hi tyre only done 400 miles max gone to a 17 inch back wheel so comes as is, mint wheel 4.00 x 18 91-93 with cush drive renthal sprocket .
a new bt014 if you can find one £147.00 so fifty quid all in
going to anglesey racing 15/16 oct so will put it up for sale there if no takers

yep still got wheel & tyre

shock done about 5000 miles all works good including adjuster

SOLD SOLD SOLD!!!!!!!hi for sale bt014 150/60/18 on 4inch rim with sprocket carrier ,koni rear shock , hugger for 91/ 94 diamond swing arm all good condition shock £45 tyre+wheel £50 hugger £25 would prefer cash on collection as posting adds to the price or get your own Currier im in chester uk emai...

hi there is a quick bodge to get it running to see if there are more faults , but in the end you will need to strip and clean the carbs . first remove tank cover ,air box so you can see carbs now start bike get it warm off choke put hand ie block no 1 carb and rev at the same time this creates a vac...

hi had the same trouble years ago when i serviced my fzr tried everything cdi,coils,leads battery,reg/rec, in the end, it was ngk plugs will never buy a set again !!! they seemed to spark ok but when looking closer they were tracking down the side insulator . changed plugs and all were fine. hope yo...

hi did the same snotted off at a round about ,if it has just broke the thread off you will be ok it is the genny cover and holds no oil, if its more than the thread you could try some of the epoxy weld that's on the market , going down on that side can lead to a bent crank nose, bike gets really vib...

hi sent out fri 1st class hope it goes well

hi one push rod [clutch ] please send address i will post tomorrow afternoon

hi if they are the delkavic ones then yes they are good quality, got some on mine. just to say ive had them for years when they first started making them , i believe they are a bit thinner now but still stainless so should last

cheers top man will send email asap been on his site got some good stuff cheers for the link

hi need a front mud guard for fzr600r 4jh 94-96 please help. doing front end conversion chester uk